Description

Product introduction
Contains 50% skin care ingredients. A sunscreen for the face and body that contains the whitening active ingredient “m-tranexamic acid” *. You can remove it with soap. Waterproof that has been confirmed to be water resistant by a water bath test. * Tranexamic acid that suppresses the production of melanin and prevents spots and freckles

What is SPF value?
It is a numerical value that shows how long it can prevent UVB waves that make the skin red and tingling.
SPF1 can prevent sunburn (red and inflamed sunburn) for 20 minutes.
・ SPF value 10 → 200 minutes (3 hours 20 minutes) ・ ・ ・ Within sunshine hours
・ SPF value 20 → 400 minutes (6 hours 40 minutes) ・ ・ ・ Sunshine hours
・ SPF value 50 → 1,000 minutes (16 hours 40 minutes) ・ ・ ・ Far beyond the daylight hours
What is PA value?
This is a guideline for how much UVA waves, which are said to accelerate skin aging, can be prevented.
PA + → UV protection effect ・ ・ ・ Measures against UV rays in daily life
PA ++ → UV protection effect is considerable … Measures for daily life UV rays and outdoor activities
PA +++ → Very effective UV protection … Measures for long outdoor activities
PA ++++ → Extremely high UV protection effect

Precautions for use
Be careful not to get this in your eyes. If it gets in, immediately rinse with cold or lukewarm water. After use, wipe the mouth of the container clean and close the cap properly. Keep out of reach of infants. Do not leave in the sun or high temperature. If it gets on your clothes, immediately wash it off with detergent. Please avoid using chlorine bleach as it will turn pink. If it gets on anything other than clothing, wipe it off immediately. Be careful not to get it on furniture, accessories, nails, leather products, etc. as it may discolor or be damaged. Please note that if the skin after application is rubbed against clothes or car seats, it may remain white. * The SPF and PA indications of the product are the results measured by applying 2 mg per 1 cm2 of application amount specified in the international SPF test method to the skin.

Raw materials / ingredients
Tranexamic acid *, purified water, diisopropyl sebacate, ethanol, 2-ethylhexyl paramethoxysilicate, methylpolysiloxane, 1,3-butylene glycol, sucrose fatty acid ester, 2,4-bis-[{4- (2) -Ethylhexyloxy) -2-hydroxy} -phenyl] -6- (4-methoxyphenyl) -1,3,5-triazine, 2- [4- (diethylamino) -2-hydroxybenzoyl] benzoic acid hexyl ester, water-containing Silica, concentrated glycerin, polyoxyethylene hydrogenated castor oil, 2,4,6-tris [4- (2-ethylhexyloxycarbonyl) anilino] -1,3,5-triazine, sorbitan sesquiisostearate, crosslinked N, N-Dimethylacrylamide-2-acrylamide-2-Methylpropansulfonate sodium copolymer, polyoxyethylene / methylpolysiloxane copolymer, isostearic acid, dibutylhydroxytoluene, succinoglucan, hydrophobic hydroxypropylmethylcellulose, edelweiss extract , Cha extract (1), Sakura leaf extract, acetylated sodium hyaluronate, Tormentilla extract, Aloe extract (2), Water-soluble collagen solution, Phenoxyethanol, Fragrance, Low-temperature calcined zinc oxide * is not labeled as “active ingredient” “Other ingredients”

how to use
For the face and neck, take an appropriate amount at the end of morning skin care and apply it evenly and carefully. For the body, take a line directly from the container onto the skin and apply it evenly in a circular motion with the palm of your hand. If the amount used is small, the UV protection effect will not be sufficient. If necessary, reapply after sweating or wiping with a towel. When removing it, wash it off carefully with your usual cleaning agent.

Note (Disclaimer)> Please be sure to read
Not applicable